Posted by Janicholson on May 25, 2011 at 19:33:13 from (67.72.98.45):
In Reply to: trees harvestors posted by cjmal on May 25, 2011 at 10:42:43:
My dad sold veneer logs to a company 20 years ago. The trees were Marked by a Forester, and a contract with Bonding was established and signed/Notarized.
Trees were "as is standing alive" (no rejection of trees after harvest if voids/rot defects were found)
All limbs not used greater than 14" diameter were to be cut to 14' or shorter lengths and skidded to an open accessible location (specified)
Skidder tracks were to be filled in if deeper than 6 inches, or down a hill.
All small limbs/branches (3" or less) were to be recut so that slash was no more than 2 foot from ground.
The process took about 3 weeks, and was watched by Dad and my Brothers and sister. (not every second, but daily.
The forest was not harmed, in fact it was revitalized. Secondary damage was minimal.
The key was preparation, references, Forester, Bonding, and Contract.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.