Posted by Don-Wi on May 20, 2011 at 23:49:13 from (75.207.174.201):
I got a good start today replacing steel on the manure spreader that supports the load on the hitch, but now tomorrow I've got a wedding I can't get out of. I should need less than 1 day of welding yet and I think we can flip it back over, but I can't keep thinking about it.
I finished welding up the hitch today at work, brought it home and cut out some steel on the front of the box that was rotted out, and then cut a good chunk out of the old hitch to splice in. That was 2 channels welded together to make a box, so I took a slitting disk and slit the welds, and cut out some 18" peices. I then cut out on the frame at a 45* angle where they were rotted and fitted the new peices in, matching the angles and tacking in place with our small wire welder. Put 45's on the front corners so I could put in the new peice for across the front I had made at work, and tacked those in as well. Then I welded everything together with 6011 rods and I have the structural part of the spreader just about fixed. Gotta grind off some of my welds and see what we've got to use for a fish plate at the joints. If I've got any undercut on those welds I'll probably fill them in with the wire machine just to prevent any cracks from developing. The penetration should be there to hold it already from the 6011 rods, and the wire should be fine for filling in where needed.
No pictures for now, but I have the camera set on the table so I can try to remember it on Sunday when I go back to finish it up. Gotta say I think my vertical up welds turned out pretty decent. Never had much practice with those before, but get the chance once in a great while.
I'll be happy once it's done, and I'll cry if something else breaks on it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.