Farmall & IHC Tractors Discussion Board |
F12 headgasket leak
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MikeH-Tx on January 02, 2001 at 10:11:25 from (192.55.23.50):
I thought restoration was done on my F12. Turns out once more that (as Roger Welsch would say) there is still some more fun left in her. I have had enough fun - now I want it to run. After reassembly and putting fluids into the tractor, I started cranking and noticed that antifreeze is seeping out of the headgasket. This was not happening prior to restoration, so I didn't expect (or look for) any cracks in the head or block. I will, once I disassemble it again. Questions: I just assumed that the headgasket should be put on without any sealer (dry). I torqued the head down to 130 lbs, starting in the center and working outward both directions. Neither of these points is covered in any of my manuals, but from experience, seems right. Also, I think I remember that you can find cracks by rubbing a cloth soaked in paint thinner over the surface. A crack will absorb some of the liquid and show up. Right? I will use a new headgasket, regardless of whether I find cracks or not. Any advice on these issues?
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|