Posted by IAtractorKid on April 20, 2014 at 06:54:28 from (184.97.55.91):
OK guys, my aunt finally got her M over to me and I was able to check it out a little last night after getter the Farmhand loader pulled off. She said that it keeps fowling the plugs and is hard to start and runs rough. It looks like oil is weeping out of cylinder 3 from the exhaust manifold and from the head gasket on the other side of the block. I pulled the plugs and cylinder 3 was dripping with oil...the others weren't too bad. She was told to use Autolite 388 plugs, I'm guessing that is hotter than the 386 that I'm thinking it should have? I was VERY shocked with the compression numbers of 130, 122, 140, 125. What do you guys think at this point? Initially I was thinking valves or rings but with compression numbers that high...would it maybe be valve guides instead? Either way I know I'll have to pull the head and pan to inspect and measure everything for wear. Just curious what you guys would be thinking at this point. 46 M with I believe an F4 magneto.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.