Posted by The tractor vet on December 18, 2012 at 11:15:07 from (75.24.4.81):
In Reply to: fasthitch posted by KY on December 18, 2012 at 10:53:24:
Myself i like the ones that i use to reproduce as the would do the Cat. 1's and Cat 2's just by removing two bolts and swing them. and i would make up a floating top link bracket for the cross bar on the fast hitch. I have one set left that i use on my 806 and they are tough enough for pulling 4x16's or chisel plow . But mostly used now on the bale wrapper. I made a bunck of them up during my slow time and sold a set or two at each auction i went to or sold them with any fast hitch tractor i sold .The hard part about making them is the bar stock for the points is hard to come by and i would have to buy over 80 feet at a time . I had a local weld shop that had a computer controlled torch cut the points out for me as they could do it way faster then i could free hand .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.