Farmall & IHC Tractors Discussion Board |
The startin and diein blues (Ken, look here!)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ludwig on October 24, 2000 at 14:41:56 from (216.41.30.221):
Super M is pullin the same old tricks.... Last Memorial day I put a new sediment bowl gasket on. That seemed to fix my problems... Saturday I went to start it, before I did I noticed the bowl was full of crap. I dumped the crap, drained the tank and flushed good.. Now when I put the bowl on and get it good and tight NO GAS COMES IN!!! It seems air bound. If I drop or otherwise loosen the bowl, the gas comes in, but the bowl leaks. If I loosen the line to the carb the bowl fills but the line leaks. Finally I let the bowl fill and then tightened it up. This seemed to work, but the tractor would run and then quit unless I kept it at half throttle where it would run fine, but wouldn't do any work. I could go to full throttle for about 2 minutes but then it would starve, drop back to half and all is okay. From the bowl I can see a big air bubble up around the screen which jiggles but neither breaks up or goes anywhere when the engine is running. Dad suggested that I pull the drain plug from the carb and see if the bubble would move. Unfortunately I ran out of time before I could try it. If it doesn't snow too bad I get another chance at this in November. After that I'll have to wait for next Memorial Day at which time I intend to replace the whole bowl assembly since the metal of the assembly is deteriorating badly. Any ideas whats what here?
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|