How far you go is up to you and how nice of a paint job you want. This being your first, it won't be perfect and may not be very good at all. It's going to be a learning experience.
Prep for the paint and usage of the paint should all be in the instructions on the can.
You can't paint over grease, so unless the tractor is already clean you will want to clean it. A steam cleaner is best but a regular old pressure washer and any product labeled as "degreaser" for pressure washers, that comes in a gallon jug will do an acceptable job.
If you want a "factory" paint job, paint the tractor almost completely assembled. Remove any hood or other decorative sheet metal and paint it separately, but other than that, mask off tires and other rubber parts.
You can tear it down to individual pieces and paint it but that is a lot of work and you just got done doing that I assume. The upside to a complete teardown is that you can get paint in all the hard-to-reach places that nobody will ever see anyway.
I recommend installing a set of junk spark plugs and removing the wires completely. I've been told that getting any paint at all on a spark plug seems to ruin them. Maybe an old wives' tale but I haven't taken chances yet and I haven't had any problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.