Posted by Rootsy on July 23, 2012 at 19:52:41 from (174.124.167.104):
Started off with replacing the left side outer axle seal which opened up a real can of worms... Going to be an expensive morning tomorrow... Inner and outer axle bearings, pinion bearings, bull pinion bearings... seals... gaskets... To think she made the 20 mile Mackinac Bridge ride in 2009 and aside from a little oil leaking out of the housing and onto the rim now and again sounded fine... Internally, it sure isn't. Ring / Pinion backlash is about 60 thousandths, minimum, and the roller bearing supporting the end of the pinion was GONE, the rollers were in the bottom of the case. The ball bearing wasn't far behind... Lucky it didn't grenade... Though the right bull gear is newer and tried to eat it's way through the rear-end housing at one point in the past...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.