Posted by gene bender on July 22, 2012 at 07:57:41 from (67.55.226.123):
In Reply to: SUPER A GOVERNOR posted by tractornaa on July 22, 2012 at 06:20:34:
If you rotate the shaft endways then it will not enguage the pin. They all have that much endplay when the shaft is rotated. Just get the shaft so it enguages the pin and it will be fine. Does the spring have good tension and the input lever does it have a lot of slop as it can be rebushed to be like new again. Ive rebuilt many. Is the throttle adjustment correct. With engine off remove the pin in the clevis going to the carb. Now open throttle wide open and adjust clevis so the pin goes in when the carb rod is held wide open. This adjustment is important. The lever on the carb mite be loose on its shaft thus not letting the butterfly do its thing. Make sure the two springs on the throttle rod coming from the steering support are free and not bound up with paint,grease or just rusted fast.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.