Posted by pete 23 on July 13, 2012 at 15:14:52 from (74.32.238.2):
In Reply to: Voltage Issues in 450 posted by Joel Wilson on July 13, 2012 at 05:28:42:
Pretty easy to test to see if cutout staying closed. With engine just shut down, unhook the wire from gen arm terminal and see if it sparks, or put a test lamp on that terminal. If cutout is sticking it will fry that generator real fast along with the points in cut out. Way too many cutouts get blamed for some other problem. You can take the cover off regulator also, but, when doing that it may not test the same as it changed the magnetic field a little bit. Cut out should close at just a little over battery voltage, about 6.6 volts and open with just a few amps of reverse current flow when shut down or even idled down slow depending on generator etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.