Posted by Janicholson on June 23, 2012 at 07:30:44 from (96.24.99.126):
In Reply to: H ampmeter jumping posted by j hakenwerth on June 23, 2012 at 05:55:40:
Mechanical voltage regulators are electrically noisy. They produce variations involtage output that ---average--- the desired charge voltage and current. from a millisecond to millisecond view, they produce voltage from below bat voltage, to twice the bat voltage. Batteries and lights do not care as long as that average is ok on a second to second basis. Amp meters of best design use a resenous liquid on one of the pivots for the needle. This sticky viscous material dampens the needle fluctuation and produces the steady needle showing an average charge rate. (This is not the only method, but common) The electronic controls of newer equipment and cars (if equipped with a gauge) would need much less dampening if any. Original meters can and do have this material dry out and stop working, new less expensive meters don"t even have it. Thus your viewing the needle jumping around might be irrelevant but distracting. Swinging through full scale side to side is an indication of connection problems, or generator/VR issues. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.