Posted by Janicholson on December 23, 2011 at 10:36:50 from (96.24.99.126):
In Reply to: Cub cyl. Head posted by BenB on December 23, 2011 at 09:46:28:
If the head is like a QWERTY keyboard, the sequence would be Y-B-U-V-T-N-I-C continue that pattern to the ends. Start with 10 ft./#, then go to 25, then 50, on up to the correct torque. Run the engine to operating temp, then let cool and retorque. If the bolts seem to not want to tighten any farther than they were, I loosen each one (one at a time) till the wernch just turns the nut a tiny bit looser, then tighten. If they tighten at first, just do that. My process breaks the static friction and allows a trew torquing of each. Do not loosen them more than just a tiny turn of bolt, and only one at a time. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.