Posted by Tom Fleming on August 09, 2011 at 07:48:50 from (67.20.249.95):
to be honest, 9 times out of 10, I get partway through the drilling and the broken off piece comes loose. Also, it is helpful to start with a drill bit that is 2-3 sizes smaller than the final size for tapping. Work your way up. Patience here is critical, but I have always gotten good results with this method.
I just got done rebuilding the carb for my regular. The idle speed screw broke off flush. It was steel, and the carb is brass. Nightmare thoughts. However, I started with a small drill bit and worked my way up, slowly and patiently. Ended up having to drill to the final size for the tap. Had to buy an uncommon tap size 12-28. All turned out well, and the new screw goes in like a champ.
Bottom line, take your time, drill it out, and retap if necessary. Worst case, you can JB weld a new bushing in there if necessary, or have one brased in if a total melt down occurs with your efforts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.