It's kinda weird that the designer replaced one worm and sector with another. Perhaps it has a higher ratio for easier steering. Have to wonder how well the seal near the pitman arm will hold up. I'll bet the IH seal was leaking and that is why the steering was replaced.
But we've been shown this tractor and the one Dr. Bert modified one page ago. That was a M with a Schwartz wide front. It seems to me if one is going to mess around with steering, why not do it with power?
It's so easy with hydrostatic components. All you need is a used four port "hand pump", an actuator for around $100 from Surplus Sales, a hydraulic power source, and misc hose and fittings. Now you have something of value in an age where even the smallest Kubota has PS as standard equipment.
Well, I am not complaining. To each his own. I just retrofitted a W-400 with hydrostatic steering for about $300. I needed to clear space on the left side of the tractor where the 6' long drag link gets in the way.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.