Posted by Larry B 1486 on April 27, 2010 at 04:43:32 from (67.142.161.31):
In Reply to: hot 2 turn fuel up? IH posted by farmallfan00000 on April 26, 2010 at 15:36:32:
Take the cover off the top of the injector pump, has four screws. Under the cover you will see a screw with a screw driver head with a lock nut and a metal tab bent over the lock nut. You have to back that screw out. You need to put it on a dyno to see how much hp you are turning. I think factory was around 125 hp but know some were turned up to 160 hp. My 1466, backing the screw out a half round gave it about 15-20 hp. It was factory 145 hp and I have it running around 160 hp. but with a load the engine temp runns a little warmer. With out a dyno you could be asking for trouble. Going over 20 hp. ( just my oppion ) is just asking for a melt down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.