What Bob is saying is to use a socket smaller than the inside dia of that yoke and it will bear against the end of trans input shaft. I am wondering , how much play do you have on that shaft, up and down, if any amount you are basically wasteing your time putting a seal in . I almost always pull the whole input shaft assembly so you can do it right. More than likely the pilot bearing inside will be shot and both ball bearings on input shaft are loose. If you have a belt pulley attachment , you need to take that off also if doing this,(then throw the whole thing away and put a plate one top, I hate them darn things). Don't attempt to put input assembly back in without being able to make certain pilot bearing is getting into input properly. Just my way of doing things. I am going to add something else here. What I have seen several times when someone removes yoke and reinstalls it from underneath, is that the half moon key comes out of place, crawls up out of keyway and thus damaging the yoke. Just be extra careful that key stays in place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.