Posted by Red Mist on February 12, 2010 at 13:14:35 from (67.142.130.21):
In Reply to: Best plug for H posted by Thumbanger on February 11, 2010 at 11:12:37:
D Slater said: (quoted from post at 11:45:58 02/12/10) CNKS, no it didn't make it in the parts book, but IH sent out a bulliten to the parts system that the governor control 51348 DAX was being replaced by 361244R11. New sector has square notches compared to present part with saw tooth type notches. Effective at serial # 26561 SH and 71718 SMTA. Both made in May 1954. States that new design complete will interchange with the previous type. Square tooth was also sold under part # 366727R91 and maybe others in IH parts merchandising catologs. Later type was used as replacements after saw tooth type run out and its probably a rare tractor that never had those parts replaced more than once.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.