Posted by ScottyHOMEy on September 09, 2009 at 03:50:25 from (70.105.246.229):
In Reply to: Re: IHC Magneto Timing posted by WayneMo on September 08, 2009 at 20:11:37:
Kirk has it right. The mag at rest has no advance and is set up at top dead center. Running, it is a flat 35 degree advance at any speed, no variability as in a battery igntion distributor.
There is no scale on the motor to check and set running advance with a light as you might find on a car motor. You don't say what your tractor is. If it has a 113 or 123, it takes some measuring and figuring, but you can make your own marks -- one on the timing cover and two on the crank pulley, one at TDC (for static timing of ignition and valves) and another at 35 BTDC just to check the running igntion timing. If it's an H or M, it already has the first two marks and you only have to determine where the spot for 35 degrees is and mark that.
Only caution I'd offer about moving the mag to advancing your running timing any further than where the mag runs is that it will also advance the static timing. Any advance on a static motor can cause a handcrank to kick back viciously. If you have any plans about using the handcrank, you want to develop some real good discipline about doing that safely, which isn't a bad idea anyway, even when set up at TDC.
Set it up by the book and see how it runs. If there's problems check back.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.