Posted by Dave H (MI) on June 03, 2009 at 18:16:39 from (205.188.116.73):
...could you tell me:
I am spending a lot of time making sure my mower is adjusted properly. Put in a new knife and was noticing that a couple of the knife clips are not keeping the sections close enough to the ledgers. In other words, when the knife section slides thru the guard it is almost 1/8 inch above it's ledger plate. Clearly not what is intended and not going to give me the best cut. I tried removing the shim from under one of the clips but that lowered it only a little and I still have a gap. I was hoping some of you all with experience with these mowers could tell me what the fix is. I replaced the bolts on the guards in those areas also and snugged them as tight as they would go. Does something need to be "modeled"? I don't want to go banging on stuff without knowing what I am doing so I thought I would ask first. Some of these parts look cast and I am not sure how much of a hit they can take.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.