Posted by spiffy1 on May 11, 2009 at 07:28:19 from (70.41.137.72):
In Reply to: 10-20 steering posted by Bob on May 10, 2009 at 10:46:04:
I have the 15-30 set-up stuck in my head right now [which didn't have the offset to tighten the gears like a 10-20] but if the worm is less than half the problem - you may be able to treat it like a 15-30:
remove the linkage arm, remove the shaft assembly and turn the shaft 180 before reinstalling the linkage arm. If that was already done once [and now with the 15-30 brain block in my head, I may be wayyyy off], it still likely leaves you with 2 more spots as the wear happens more in a 90 (actually probably more like 30!) degree area, but bolt reliefs were not provided in the perpendicular directions so if you grind in bolt reliefs and you may be good to go twice more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.