Sounds like your BN is an old-timer. The plate you describe should have a point on it that is visible below the edge of the flywheel, and is the timing mark. They only used that on the first 35,000 or so As, Bs and BNs before changing over to the cast nub sometime in 1940. I'd never seen one until last week when we split a friend's 1940 A. If the plate doesn't reach low enough, you could use a T-square or another rig to extend a line perpendicular to center of the top edge down to the circumference and mark it with paint, too.
A couple other thoughts. If you haven't already, it's a lot easier to line up the motor if you remove all the plugs while you're doing it just so you're not fighting any rebound caused by compression.
As far as the rotor position, 1-2 o'clock is normal for #1. There are several ways to have gotten to where you are. The most common is for the distributor to have been set up with the engine at TDC on exhaust. That, and as Jim N (Ithink it as him) mentioned, setting the rotor up to point generally to #1 before installing the distributor with #1 at TDC on compression would avoid that.
It can be timed to run the way you have it now -- as long as you have spark at the right wire at the right time, it doesn't make any difference to its running where that wire connects to the cap. I'm just thinking of the next guy. ;8^) Easy fix if you want to do it now, and that is to get #1 to TDC compression, make a crayon mark on the distributor body that lines up with the #1 tower on the cap, pull the cap off so that you can see the rotor, then pull the distributor back off and turn it by hand until the rotor points to your mark, then reinstall everything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.