Posted by coytee on November 22, 2008 at 11:23:56 from (207.65.105.178):
We"ve got an international 886. It has power steering and today, I noticed some oil dripping from the steering box connected to the steering WHEEL. This is up in the engine compartment.
The steering box, seems to be a round, 3-part cylinder with 8 or so, bolts on the bottom, holding all three parts together.
I don"t yet have a socket thin enough to see if its loose bolts BUT...here"s my issue:
Looks like when the tractor is running and pressure is up, hydraulic fluid is just weeping from the two seams where the 3 parts are compressed together.
This could EASILY be some loose bolts on the bottom but.... I"m wondering... what if it isn"t?
What might cause oil to leak from BOTH seams on this?
Are these rebuildable (worst case scenario) or can I get gaskets and replace them (better case scenario)
Looking like I need a thinwall socket for this?
The bolt heads look to be flush with the bottom of the "cup". Meaning, the bolt heads are actually recessed a bit so I can NOT get to them very easily.
Thanks for any thoughts
I don't know if this will work but I found this on their website:
This is I think the blow up of the whole assembly and oil is seeping out of the seams between parts 26, 24 and 31 (part 23 I think either goes inside the others or doesn't exist on my tractor)
part (bolt) 27 is the part that's recessed and I can't get a socket on yet. (only had impact sockets which are thicker)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.