Posted by Owen Aaland on June 14, 2008 at 12:25:43 from (65.174.247.105):
In Reply to: 400 Axle housing posted by Ron Muhlenkamp on June 14, 2008 at 05:43:42:
Ron Muhlenkamp said: (quoted from post at 05:43:42 06/14/08) Thanks
Can the housing be removed without pulling the axle
Ron
No. The inner bearing is retained into the housing with four bolts. You would have to get those bolts out but they are behind the bull gear. You would need to get the bull gear off the axle to gain access to them. Once you have the bull gear off the axle will already be most of the way off the bearing.
With the outer bearing cap off, remove the PTO. Remove the bolt that holds the bull gear on the axle. Remove the washer and reinstall the bolt. Put a spacer between the axle bolts and back the bolt back out again. As you back out the bolt it will push the axle out of the bull gear and bearing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.