Posted by CtryBoyInMT on May 19, 2008 at 14:55:40 from (64.136.221.16):
Can anyone tell when what each of the adjustment screws are for? Also do you have a solution for the wandering idle problem?
The carburetor was shooting gas out the overflow hole from a stuck float. So I took the carb off and put in a new needle/seat and float along with new gaskets. Then as I was setting the carb, the idle wanders. Also it full throttle it coughs and can hardly even sustain PTO rpm. My first thought was vacuum leak at the carb base, but I resealed it with Permatex along with the gasket. Then I thought it was fuel starved, so I made sure the bowl was full of fuel. No fuel flow problems (To the carb and into the bowl anyway).
The most unusual thing is that it will run and pull a load fine with the choke ¼ of the way out. I ran what I believe is the mixture (bottom of float bowl) screw out and it never smoothed out. In fact, I ran it all the way out to where gas was starting to drip past and it still never ran rich. The plugs are pure white from being lean. I then sprayed carb cleaner all around the carb, carb gasket and manifold gasket. If it is leaking from any gasket, I can't find where. Any Ideas?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.