Ya have any of the old harness to work with???? If ya do then use my trick of building a new one . I use a 2foot by 8 foot piece of plywood and lay out the old harness on it and use finish nails to hook the old wires streched out and hook the ends over the nails . Then strip off the cover and see what color wire and size of wire and mark it on the board . IF it has and alt. i use a 10 Ga. for the main wire from the hot post of the alt. to the amp gauge then from the amp gauge to the starter . Then after i have all the layout work done i remove the old harness and start laying out the wires to each nail on the board . Myself i use uninsulated ends then i use a real good heat shrink over the ends or terminals to give the factory look . IF ya have wires that were broken off the org. harness then leave them long and finish them once on the tractor for the correct length . One trick that i do for a generator to alt. change over is i use a cv relay to energize the alt. and forget the ligthbulb or diode . As for the wire loom after years of tracing it down i found a wire supply house that i could get the factory style loom and with practce one can make a real factory look to it .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.