Red Mist said: (quoted from post at 05:46:40 05/03/08) Thanks to all for the suggestions. I'm going to repeat the continuity checks on the gen and field wires to the generator posts; but this time I'm going to check them with the wires disconnected from the VR to make sure I'm getting no feed through the VR. I am now wondering if the field and arm wires are crossed with each other at the generator? That would explain the full "discharge" when I jump the VR from the batt to the gen posts. mike
Well, I repeated the continuity checks from the VR to the generator - but this time with the ends of both leads disconnected. Thus, I got a true reading. (Last time I did not disconnect the leads.) Sure enough, the leads were crossed at the generator. I reversed them to correct the problem, polarized the generator and started it up to 3/4 throttle. Ammeter went positive and measured voltage taken at the battery posts showed 7.40V within just a few minutes. Sweet. This is the first job I've tackled on this beast that has not cost me an arm and a leg. Maybe we'll bond with each other afterall......
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.