The compression should be 80PSI or so. something is wrong in this process. Here is my opinion (I know it may sound redundant, but humor me) with the plugs out, and valve cover off, use a hand crank, or jack up one rear wheel and use high gear to rotate the engine. Place a stiff 1 foot long piece of copper wire in the #1 plug hole. rotate the engine to be sure it is at TDC (and on the timing mark, and the rotor is pointing to #1 cap terminal). The valves will now be closed on #1 cylinder Rotate the engine slowly in the correct direction. The valves will remain closed for 1/2 revolution. THe exhaust valve will begin to open when the piston begins to go back up. At the top of the stroke the valves overlap, and both are kinda open (exhaust closing, and intake opening) The TDC mark will go by, and the rotor will now be pointing 180 degrees from the #1 terminal, to the #4 terminal. Continue to rotate as the piston goes down, the intake will remain closed till about the bottom of the stroke, then it will close (both valves now closed) Turning farther will bring the piston back up on the compression stroke. Valves will remain closed through this motion. If this is not what is happening, the cam is out of time. Also: If you set the valves when the piston is at TDC on compression, they will be correct. Best of luck, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.