Posted by glennster on October 17, 2007 at 14:04:34 from (76.224.26.7):
In Reply to: Tight Tire Bolts posted by WonderingAl on October 17, 2007 at 10:16:11:
like steven said use a penetrating oil. i like pb blaster, any autoparts store sells it. if there is paint on the threads sealing the nut, wire brush some off so the oil can creep in there. if you dont have acess to a cutting torch or impact, try a propane torch and just warm the nuts up some. this will cause them to expand, then spray em up. if i remember, the h uses a 7/8 or 15/16 nut. see if you can buy or borrow a 3/4 drive breaker bar and a socket. get the breaker bar on the nut and rock it back and forth just enough to get it to move, then spray it up some more. you should be able to get them off then. run the nuts almost all the way out, then get the wedges loose. be careful if the tire is loaded with chloride and water, its real heavy,maybe 5-600 lbs. you may have to let the nuts soak for a day or two. chase the threads with a die before you put em back on, i dab a little anti seize on the threads too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.