Farmall & IHC Tractors Discussion Board |
Re: International Super M-1951
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 29, 2007 at 16:37:04 from (66.173.50.128):
In Reply to: International Super M-1951 posted by Keith Jasinski on January 29, 2007 at 14:03:17:
First find out which cylinder it is. Pull off one plug wire at a time (using plug wire pliers or well insulated pliers) as each is removed and replaced, one will make no difference. That is the focus. Change the plug in that cylinder with another and retest to see if it followed the plug, if so replace the plug, if not, pull the plug from the cylinder that is not working and test the compression again (with throttle open) If good compression, we need to focus on intake. Use the choke to richen up the mixture till it begins to run rough (not full choke) and see if at some point the engine picks up that cylinder. If so there may be a vacuum leak letting air in that runner of the manifold. Use an unlit propane torch (outside) while it is running and missing. Pass the torch nozzle around the intake manifold to see if it picks up the cylinder. If so there is your leak. If not, I would pull the valve cover off and look at the valve train to see if a valve is stuck, or not moving. Worn out cams, misadjusted valves, and broken bent pushrods will cause that miss. Good luck, JimN
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|