Farmall & IHC Tractors Discussion Board |
Re: Farmall Regular Crankshaft Removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JohnG(TX) on November 28, 2006 at 12:30:46 from (216.136.20.34):
In Reply to: Farmall Regular Crankshaft Removal posted by Wayne Ellingworth on November 27, 2006 at 17:20:06:
I have pushed the crank out from the front by making a puller from a 4x4 and threaded rod. The threaded rod goes into two of the front cover holes and the 4x4 is drilled to fit over the rods. Chose two holes as close to directly opposite the crank centerline as possible. Mine did not line up perfectly, but worked well enough. Once I got everything set up and tightened down, I gave the center of the 4x4 a good rap with a sledge and that started the crank moving. From there, I just kept tightening the nuts on the all-thread until it popped out the back. I pull the flywheel in much the same manner with good results.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|