Farmall & IHC Tractors Discussion Board |
Re: ih384 valve settings and alt belt
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fromjb2 on September 20, 2006 at 18:29:46 from (69.198.143.165):
In Reply to: ih384 valve settings and alt belt posted by sotxbill on September 20, 2006 at 14:00:12:
Hi Bill, The 384 like the B414 has a split pulley on the water pump. From B414 operators manual removing the fan belt: to remove the fan belt loosen the set screw in the flange of the water pump pulley and unscrew the flange as far as possible. Start the belt out over the outer flange of the crankshaft pulley and pry out with a light bar or rod. Slowly turn the engine over at the same time the belt will work off the pulley. Withdraw the belt between the Pulley and the fan blades. The belt can now be worked over the fan blades. Not much room to work in there with the fan guards. Hope this helps JB2
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|