Farmall & IHC Tractors Discussion Board |
ATTENTION ALL 300 350 UTILITY OWNERS, hydraulics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Terry Miller on August 08, 2006 at 04:34:24 from (208.134.202.37):
I am still trying to get my hydraulics and the 3pt working. Sunday I took the seat off and removed the vent to the hydraulic fluid housing, and put the air hose to it, and as soon as I did that I had instant pressure and the 3pt worked great, fast up and down, as soon as I removed the air it slowed and eventually quit again. Is it possible the screen is plugged, or something else? I started to remove all the bolts last night as to remove the whole cover under the seat and noticed the four tapped holes on top, must be for lifting it as it looks extremely heavy. My hyd. valves (2) sets are located just to my right as sitting, and look to be attached the that lid. Can those stay if I need to lift it? This all started when I removed the two hard lines to have a hole brazed,and replace the o rings, although it has always been slow.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|