Farmall & IHC Tractors Discussion Board |
Re: Attn: CNKS Need more brake info
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Harold Hubbard on July 02, 2006 at 18:03:37 from (66.6.176.23):
In Reply to: Attn: CNKS Need more brake info posted by Bootman on July 02, 2006 at 17:12:49:
DO NOT try to take that plate off. It is the bearing retainer for the pinion shaft bearing, and it is notched out on the back side for the axle bull gear. If you try to pull it out, it will catch on the bull gear and probablly break. I did that exact thing once on a C, and it was a long time before I got back on good speaking terms with the owner, who was my father. Just find some way to destroy the seals from the outside, and pull out the pieces. One thing that sometimes works is to screw a dent puller into one side of the seal and beat it out .
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|