Farmall & IHC Tractors Discussion Board |
Re: Super A Steering Worm Gear Cap Removal Questio
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by scotty on April 07, 2006 at 07:13:08 from (199.231.49.128):
In Reply to: Super A Steering Worm Gear Cap Removal Question posted by kevinez on April 07, 2006 at 05:21:47:
Mornin Kevin, Hugh has given some good advice, I have only pulled apart a couple of those steering boxes, some light amount of heat may help you out! When you do finally get it apart, you can take some of the slop out by putting a large washer between the outer bearing race and the inside lip of that castle nut your trying to remove. What this does is reduce the axial float on the steering shaft. Hope this helps. As Hugh has stated, the steering arm shaft exiting the bottom of the steering box can have a loose nut, worn woodruff key or both. On my Super A I had other problems like the tapered lock bolt that connects the steering arms to the steering spindles were also sheared :"( scotty
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|