Farmall & IHC Tractors Discussion Board |
Re: super c hyd.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on April 07, 2006 at 05:41:37 from (204.249.178.138):
In Reply to: super c hyd. posted by m+j farms on April 06, 2006 at 18:59:10:
www.saginawcountytractor.com has the best 3-points made. The web site will not show it, but there is one for a C. There is also adapter that fits between the reservoir and lines that directs the fluid the same way that the factory setup does. You mount a spool valve on the light bar or wherever you want it. Pressure line from the adapter to the spool valve, then pressure out from the valve to the 3 point cylinder, pressure line back to the spool valve, return line to adapter. I suppose it can also be setup for one-way hydraulics if you desire. This works independently of the rockshaft, you probably can't use the touch control levers at the same time as the spool valve, but you don't need to -- MUCH better than using the rockshaft for the 3 point.
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|