Farmall & IHC Tractors Discussion Board |
Re: smtad sheet metal advice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave Grindle on March 24, 2006 at 23:07:21 from (207.190.64.194):
In Reply to: smtad sheet metal advice posted by shoo_giesty on March 24, 2006 at 21:53:48:
Tim ......an M grill will fit , but you won't have the "cutivator brace" holes (thus it will be "cosmetically" incorrect) MD hoods & fuel tanks are the same as SMTAD(but the M gas is not) .......the TA does NOT make the tank or the hood longer cause the extra TA length is compensated for behind the fuel tank ( there's a gap between the tank & the stearing wheel post) the reason the MD , SMTAD & SMTA hoods are longer than the M gas hoods is in the front casting (the piece where the side rails bolt to)- this piece is about 1.5 inches longer , thus the hood needs to be longer to "reach" the grill
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|