Farmall & IHC Tractors Discussion Board |
Re: adjustment
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by kippster on February 23, 2006 at 05:42:23 from (24.144.198.230):
In Reply to: adjustment posted by randy on February 23, 2006 at 05:28:21:
There should an adjustment on the pedal itself, but there is adlustment in the linkage as well. The IT manual would probaly be of some help for you too. When the adjustment is finished you should have one inch of free play in the pedal. Also try greasing the throwout bearing. On the old cubs, there was a hand hole in the bottom of the bell housing and that was the access to the grease fitting. If the linkage adjustment and the grease don't do the trick, then you have some type of mechanical problem that will require more attention. Hope this helps
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|