Farmall & IHC Tractors Discussion Board |
Re: zenith carb which one?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark in TN on December 30, 2005 at 12:32:10 from (68.114.166.197):
In Reply to: zenith carb which one? posted by banjo on December 30, 2005 at 12:01:37:
Banjo, I had a similar problem when I went to rebuild my carb, except mine had 3-63 and B6 in the bottom of the casting. I found a place that sells these kits at www.carbsonly.com. The kit they sent was for 6 different Zenith models (61, 62, 67, 68, 161, and 267). The kit P/N was 778-615A made by BFIC. The cost was $21.95 + $4.85 shipping in '03. I think the only real difference in these carb rebuld kits is the gasket that goes between the two halves and the bowl vent. You can send them an email and they will help you get the right kit.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|