Farmall & IHC Tractors Discussion Board |
Re: Dead solid miss in 350D
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MN Scott on November 02, 2005 at 18:30:41 from (206.9.216.40):
In Reply to: Dead solid miss in 350D posted by Bleed IH Red on November 02, 2005 at 17:34:41:
The 350 has the continental engine in it. Do you have oil in water or water in oil? Are you loosing coolant? Could be a compression problem, bad valve, blown head gasket, ect. Did the miss start at once or has it been slowly getting worse? Do you hear a popping noise in the exhaust, that would indicate a bad valve. You had the pump rebuilt but not the injectors? A bad injector could have those symptoms. I would pull them first and have them tested. If they are good then you will have to go looking in the motor to find were you are loosing compression. Pistons and sleeves are no longer available for that engine but bearings, gaskets and some other parts still are. Good Luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|