Farmall & IHC Tractors Discussion Board |
Re: Spin on oil filter for 300U
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by PAULIH300 on October 14, 2005 at 17:19:45 from (64.12.117.13):
In Reply to: Spin on oil filter for 300U posted by 300Randy on October 14, 2005 at 11:47:57:
My conversion was from Case/IH....one word of caution....there is a narrow,square cut O-ring that the spin on adapter screws down against,and if you dont have that as tight as humanly possible,it will leak oil badly.I worry about how long that ring will last being compressed like that though.One crack and it will be a torrent of oil.Poor engineering if you ask me.They should have cut a groove in the adapter base and inserted a round profile ring,instead of a square one sitting out in space.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|