Farmall & IHC Tractors Discussion Board |
Re: setting tappets
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on October 13, 2005 at 08:13:20 from (70.59.106.176):
In Reply to: setting tappets posted by farmall4 on October 13, 2005 at 06:26:00:
Warm the engine so you get an accurate adjustment; have the hood off so all you need to do is remove the valve cover when you are ready to adjust. Locate #1 sparkplug wire in the distributor cap; remove the cap & rotate the engine so the rotor is pointing to #1 terminal. Adjust both #1 valves. If the spark plugs are removed, you should ve able to rotate the engine with the fan belt so the distributor rotor is pointing to the terminal of the next cylinder in the firing order; adjust those valves. Continue in the same manner until finished. The feeler gauge should have a slight dragging feel as you pull it out from between the valve & the rocker arm. If you try the next smaller size feeler, it should not have any resistance when inserting or removing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|