Farmall & IHC Tractors Discussion Board |
Pulling Rims
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GordoSD on August 01, 2005 at 15:25:56 from (64.68.166.234):
After several hours of hard pulling with cheater finally got the outer nuts and retainers off the SMTA rims. And the brakes came off easy. Now the hard part. This old gal was a dairy farm tractor. Get the picture? Have soaked the inner nuts for a couple of days. Tried the air, nope. Tried the cheater, nope, cut one with cold chisel. That's not another option. One is spinning, will need neighbor with another cheater on the other side. Only got 10 to go. What's an easier way? There's no room to use a sawsall or die cutter in there. Hell, what's the hardest way to get them off? Got to pull the wheel in order to pull the axle assembly, in order to pull the inner wheel bearing. I found a .6835 diameter ball bearing, and six pieces of the bearing cage in the tranny case bottom when I pulled the PTO.Is that the sizi of the inner axle shaft bearing balls? (note: no half moon key in the pto shaft keyway). Have a mountain of parts laying on the floor and I'm not 1/2 way there yet? Gordo
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|