Farmall & IHC Tractors Discussion Board |
544 axle slop
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dave from MN on March 29, 2005 at 06:12:46 from (67.2.202.201):
Lifted the front end up with the loader and safety blocked. About 1/4" of play for the front axle between the bolster. I found no cracks in bolster.The axle seems tight on the shaft and moved freely. Shaft does not seem broke. I assume cast wont bend. I did how ever find a lot of slop in the part that the torsion bars( at least that is what I call them) mount to the frame. There is a peice that goes through a small block that is bolted to the frame. This small short shaft appears to go into the back of the center of the torsion bar is. Does any one know if this is supposed to be tight, one peice . I was unable to get a pic this am and if no one responds knowing what I mean I will try to get a pic posted later today. My father wants to use the 544 at his place today to pull down some 100 year old oaks to cut into post or grade wood. County widening road and we dont wanna see em dozed into a pile and burned. Just want to make sure tractor is safe to use. Thanks in advance to all the good people on this site.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|