Farmall & IHC Tractors Discussion Board |
Re: 1954 Cub wiring needs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave (IL) on January 22, 2005 at 23:11:13 from (67.175.146.6):
In Reply to: 1954 Cub wiring needs posted by Candyce on January 22, 2005 at 17:20:02:
Don't know Cubs specifically, but, in general, a magneto don't give a hoot about the electrical system. It's not connected at all. Only thing I can think of that might cause a Farmall confusion is that the little round push/pull switch that an H has is open when pulled out for mags and closed when pulled out for battery ignition. On a mag H the wire runs up to the grounding terminal on the mag. Push button in, switch turns on, grounds the points in the mag to kill it. On a battery ignition H, that button has batt on one side and a wire to the coil on the other. When you pull it out it turns on and puts voltage on the coil. At least that's what I think.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|