Farmall & IHC Tractors Discussion Board |
Re: 400D Flywheel Weight?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B.-826 on January 11, 2005 at 17:39:32 from (209.163.30.22):
In Reply to: 400D Flywheel Weight? posted by Farmall Frank on January 11, 2005 at 15:46:28:
I've never worked on a 400 Diesel. Most of my tractor experience comes from 70-100 horsepower IH's. Really, the flywheel shouldn't be that bad. Remove two flywheel to crankshaft bolts that are across from eachother and replace them with alingment dowels, made by taking two bolts that are about three inches longer, and cutting the heads off. Now remove the remaining bolts. The two alingment dowels you just made will support the flywheel while you get a good grip on it, and you'll be able to get an idea of what it weighs as you slide it off. This method also makes it about 100 times easier to install the flywheel, too. If the rear main dosen't look like it's leaking, I would leave it alone. However, since you are replacing the TA, you should also replace the main clutch. Whenever you replace the clutch, it is an extremely good idea to have the flywheel surfaced by a machine shop.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|