Posted by cessnapilot3@gmail.com on April 04, 2009 at 12:31:40 from (70.194.139.250):
Gentlemen,
I have just about got the engine out of my M. I'd like to start getting some quotes on machining, but, I have a few questions about the crankshaft:
Does the machinist need to have experience with Farmall specificallt to be able to do this?
How do I know if there is enough meat left to regrind it? I can mic it, but have no idea what the wear limits are?
Is it up to the machinist to decide how much to take off, or am I supposed to tell him?
How do I know what size bearings to get/use?
Lastly, in order to have the head and block magnafluxed do I have to removed the studs from the block and the valves from the head?
Oh...one more important one.....I need a sleeve puller any idea where to get one? I could nake it myself but am not sure how to get the bottom piece the right size/strength, I am not a machinist and do not have a lathe.
Thanks for your help, please be patient with my lack of knowledge, at least I'm trying to learn
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.