Farmall & IHC Tractors Discussion Board |
Re: How much blow by is too much?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ross on January 08, 2005 at 11:37:26 from (63.77.205.138):
In Reply to: Re: How much blow by is too much? posted by Allan in NE on January 07, 2005 at 07:48:04:
Allan could you be more specific about what you mean by just throwing in rings is a recipe for disaster? Do you mean throwing in rings without honing and removing the cylinder ridge or do you mean that since you're rebuiliding the engine to put in new pistons and sleeves. Since I'm asking you I've got an Oliver that has great oil pressure (pegs the guage), compression readings of 110, 100,105 and 110. However it smokes to beat the band mainly on start up but also occasionally under a hard pull. The tractor set for a while before I bought it so I thought stuck rings but I've got decent compression Do you think the valve guides could be the culprit? I've got no idea on the amount of hours. Thanks Ross
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|