Farmall & IHC Tractors Discussion Board |
Re: H65C Payloader help pls!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Novel Idea Guy on December 21, 2004 at 11:46:23 from (64.80.110.40):
In Reply to: H65C Payloader help pls!!! posted by Jason Barretto on December 21, 2004 at 03:36:41:
I understand that payloader parts may be more difficult to find since the Hough division of IH is long gone, but SOMEONE, be it a Case New Holland dealer or an International truck dealer, should be able to look up the engine number. If you haven't gone to a CNH dealer or an IH truck dealer, then you can't say "nobody knows," because you haven't asked everybody yet. The first three numbers in the engine code tell you the cubic inches. The prefix will be a D for a normal engine, or DT if it has a Turbo. Note that it's probably not a "D353," or "DT353" but rather a D3 or DT3. IH made a D360 for their tracors and a DT360 for their trucks. However, the first three numbers on a DT360 engine are "362" not "353."You could always get the part number off the water pump casting. Even if it means pulling the water pump and putting the loader out of commission for a little while, it's better than sitting around clueless and acting stupid...
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|