Farmall & IHC Tractors Discussion Board |
Re: Fitting a loader to 484 - how difficult to rem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB2 on October 05, 2004 at 17:06:25 from (24.157.143.220):
In Reply to: Re: Fitting a loader to 484 - how difficult to rem posted by Clanger on October 05, 2004 at 01:45:54:
Hi Clanger, the only thing I can think of for "attachment plate" is what we CNDs call a dirt plate that fits over the prongs or tines (probably tynes for UK) in the bucket for handling materials like gravel or earth. Most agricultural loaders come with a bucket with prongs in like a fork to make it easy to handle materials like manure with lots of straw in it. Industrial loaders come with a solid bucket. The loaders that I have seen for 454, 484 also fit the 584, 684, 784 and 884 tractors. The only difference in these tractors frame wise is the length of the engine so the 454 and 484 with only a 3 cyl engine have a spacer that bolt to the holes below the front grill to make up the difference in length. I still believe the spool valve will be bolted to the loader frame so they can be operated with your right hand. I don't like the ones that operate from the remote levers by your right foot. But that is my personal choice. The newest versions all have a single "joy stick" type hydraulic lever. Good luck JB2
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|