Farmall & IHC Tractors Discussion Board |
Re: Building H pulling tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on September 20, 2004 at 07:02:43 from (66.228.96.244):
In Reply to: Building H pulling tractor posted by Howard N on September 19, 2004 at 18:58:39:
Howard, here is some info you might look into for engine options. maybe go with a 350 sleeve and piston kit. If done right, you can get a solid 50 hp out of it. Manifold and carb, a Super H-350 manifold, and a M carb. If you can find a 350 engine sitting somewhere, (c-175) grab it! The cam, and cyl head in the later versions of this engine are much better than the old H, everything interchanges. Biggest bore in a H block is 3-13/16 and still run on the block, you could go up to 4 inch bore, but that is alot of machine work, but, you can use Massey 44 pistons in it, with a stock H stroke with a 4 inch bore. Hope this helps, ChadS
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|